Bright Safety Full Body Harness Haidar PN56

Jual harga pabrik produsen melayani distributor, agen, toko produk murah Bright Safety Full Body Harness Haidar PN56, Sfesifikasi Produk Bright Safety Full Body Harness: Certificate : EN361:2002, EN358:2018, EN813:2008,We declare that this product is manufactured in conformity with the provisions of council directive 89/686/EEC and with the harmonized standard EN 361:2002 the minimum breaking strength of the webbing is 22KN

Vitting intrucion

1. Locate the rear triangle
2. Fit harness over shoulders
3. Couple buckles
4. Fit leg straps left stap to left bucle right strap to right buckle do not cross
5. Tidy surplus webbing ny sliding blue slide to end of loose webbing
6. When standing straight the harness shuld be comportable without undue pressure on chest shoulders on pelvic area

That harness theat it made of polyester is designed to be used for working at a height where the provision of general building construction site, works on roofs suitable barriers or other similar safeguard is impracticable

You can put on the harness in following other :

1. Take the harness by the dorsal D-ring attacted to the plastic plate, Make sure to use only D-ring for fall arrest purpose
2. Slip on the shoulders straps one after the other taking care not to twist them
3. Adjust one end then the other shoulder stay bu pulling or releasing the slack end, so that the buttock stap is firmly in place under the buttocks
4.  Pull one and then the other thigh the crotch and latch each stap and each of the female buckles locared at the thighs, by passing the male bucle through the female, make sure not to cross the straps.
5. Adjust the tension of thigh straps by pulling and releasing the slack and of the strap, Pastening and/or adjustment element must be regularly checked during use
6. Attach the chest strap and adiust its tension to hold the shoulders straps centered on each shoulders